[PLUG] (serial) terminal condition
Pluimer, Randal T
randal.t.pluimer at intel.com
Wed Nov 20 23:31:26 UTC 2002
The switches and hubs i use here require No Flow Control and a set baud rate
or they wont respond.
IF your device is fairly old try setting to no flow control and 9600 baud.
>From there go to 19,200 and finally 115,200. One of those should work. Only
other thing i can think of is possible emulation protocol. That usually just
means you will get a garbled screen though if its not right.
-----Original Message-----
From: Jeme A Brelin [mailto:jeme at brelin.net]
Sent: Wednesday, November 20, 2002 3:25 PM
To: 'plug at lists.pdxlinux.org'
Subject: RE: [PLUG] (serial) terminal condition
On Wed, 20 Nov 2002, Pluimer, Randal T wrote:
> Most comm/management ports require specific baud/n81/flow control
> settings before they will respond. Are these set correctly?
Yeah, no parity, eight data, one stop... it auto-senses the bitrate, but
that's why you have to hit enter a few times.
Flow control is another story. There's nothing about it in the manual.
I'll try turning it off completely as Russel suggests.
J.
--
-----------------
Jeme A Brelin
jeme at brelin.net
-----------------
[cc] counter-copyright
http://www.openlaw.org
_______________________________________________
PLUG mailing list
PLUG at lists.pdxlinux.org
http://lists.pdxlinux.org/mailman/listinfo/plug
More information about the PLUG
mailing list