[PLUG] Identifying installed video board

[Rich Shepard]

On 29 Nov 2002, Russell Senior wrote:

> You might try lspci -v.

  I knew there was something else! Thanks, Russell.

  Here are the results:

01:00.0 Display controller: 3DLabs Permedia II 2D+3D (rev 01)
        Subsystem: 3DLabs AccelStar II 3D Accelerator
        Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 10
        Memory at feae0000 (32-bit, non-prefetchable) [size=128K]
        Memory at fe000000 (32-bit, non-prefetchable) [size=8M]
        Memory at fd800000 (32-bit, non-prefetchable) [size=8M]
        Expansion ROM at fead0000 [disabled] [size=64K]
        Capabilities: [4c] Power Management version 1
        Capabilities: [40] AGP version 1.0

  The bottom line suggests that it is an AGP slot card. I didn't know that
AGP takes a pci channel.

  So, I should get a replacement AGP video board. Any recommendations for a
low-end one?

Rich