[PLUG] eth0 message
Vincent Yau
v_yau3 at hotmail.com
Fri Nov 14 10:39:01 UTC 2003
Dear all:
I got a new RH9 box setup at work and just for
curiosity, I checked dmesg to make sure that
all components were ok during boot time.
I then noticed this line in dmesg:
eth0 NIC link is up 10 Mbps half duplex
I actually think that I should be getting more than 10Mbps.
I need to verify with my network support but just wondering
if there is something that I can do to set it higher on my end?
And why is it half duplex? Shouldn't it be full duplex?
thanks
--Vincent
_________________________________________________________________
Compare high-speed Internet plans, starting at $26.95.
https://broadband.msn.com (Prices may vary by service area.)
More information about the PLUG
mailing list