[PLUG] Resetting hostname and IP address
Rich Shepard
rshepard at appl-ecosys.com
Fri Jun 25 12:00:03 UTC 2004
On Fri, 25 Jun 2004, Galen Seitz wrote:
> Please post the command you used to set up the virtual interface, as well
> as the output from ifconfig and route after the virtual interface was set
> up..
ifconfig eth0:1 192.168.1.3 netmask 255.255.255.0
ifconfig -a
eth0 Link encap:Ethernet HWaddr 08:00:46:AD:87:55
inet addr:192.168.55.3 Bcast:192.168.55.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:327 errors:0 dropped:0 overruns:0 frame:0
TX packets:37 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:53003 (51.7 Kb) TX bytes:1834 (1.7 Kb)
Interrupt:9 Base address:0x4000
eth0:1 Link encap:Ethernet HWaddr 08:00:46:AD:87:55
inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Interrupt:9 Base address:0x4000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:19 errors:0 dropped:0 overruns:0 frame:0
TX packets:19 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1840 (1.7 Kb) TX bytes:1840 (1.7 Kb)
Thanks, Galen,
Rich
--
Dr. Richard B. Shepard, President
Applied Ecosystem Services, Inc. (TM)
<http://www.appl-ecosys.com>
More information about the PLUG
mailing list