[PLUG] Recommended Disk Test

Nat Taylor bioborg at gmail.com
Tue Jan 13 21:51:53 UTC 2015


all those Pre-Fail and Old_ages look suspicious...

On Tue, Jan 13, 2015 at 1:38 PM, Dick Steffens <dick at dicksteffens.com>
wrote:

> On 01/13/2015 01:02 PM, Nat Taylor wrote:
> > not sure about destructiveness of smartmontools and "smartctl -a"
>
> Looks like it's non-destructive. I got this, which appears to say the
> disk is fine, unless I misinterpreted something:
>
> rsteff at ThinkCentre-M58p:~$ sudo smartctl -a /dev/sda
> smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.5.0-18-generic] (local
> build)
> Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net
>
> === START OF INFORMATION SECTION ===
> Model Family:     Seagate Barracuda 7200.12
> Device Model:     ST3320418AS
> Serial Number:    6VM97DR5
> LU WWN Device Id: 5 000c50 01ed8e39b
> Firmware Version: CC66
> User Capacity:    320,072,933,376 bytes [320 GB]
> Sector Size:      512 bytes logical/physical
> Device is:        In smartctl database [for details use: -P show]
> ATA Version is:   8
> ATA Standard is:  ATA-8-ACS revision 4
> Local Time is:    Tue Jan 13 13:15:37 2015 PST
> SMART support is: Available - device has SMART capability.
> SMART support is: Enabled
>
> === START OF READ SMART DATA SECTION ===
> SMART overall-health self-assessment test result: PASSED
>
> General SMART Values:
> Offline data collection status:  (0x82)    Offline data collection activity
>                      was completed without error.
>                      Auto Offline Data Collection: Enabled.
> Self-test execution status:      (   0)    The previous self-test
> routine completed
>                      without error or no self-test has ever
>                      been run.
> Total time to complete Offline
> data collection:         (  625) seconds.
> Offline data collection
> capabilities:              (0x7b) SMART execute Offline immediate.
>                      Auto Offline data collection on/off support.
>                      Suspend Offline collection upon new
>                      command.
>                      Offline surface scan supported.
>                      Self-test supported.
>                      Conveyance Self-test supported.
>                      Selective Self-test supported.
> SMART capabilities:            (0x0003)    Saves SMART data before entering
>                      power-saving mode.
>                      Supports SMART auto save timer.
> Error logging capability:        (0x01)    Error logging supported.
>                      General Purpose Logging supported.
> Short self-test routine
> recommended polling time:      (   1) minutes.
> Extended self-test routine
> recommended polling time:      (  68) minutes.
> Conveyance self-test routine
> recommended polling time:      (   2) minutes.
> SCT capabilities:            (0x103f)    SCT Status supported.
>                      SCT Error Recovery Control supported.
>                      SCT Feature Control supported.
>                      SCT Data Table supported.
>
> SMART Attributes Data Structure revision number: 10
> Vendor Specific SMART Attributes with Thresholds:
> ID# ATTRIBUTE_NAME          FLAG     VALUE WORST THRESH TYPE UPDATED
> WHEN_FAILED RAW_VALUE
>    1 Raw_Read_Error_Rate     0x000f   117   099   006    Pre-fail
> Always       -       148741208
>    3 Spin_Up_Time            0x0003   097   097   000    Pre-fail
> Always       -       0
>    4 Start_Stop_Count        0x0032   100   100   020    Old_age
> Always       -       934
>    5 Reallocated_Sector_Ct   0x0033   100   100   036    Pre-fail
> Always       -       0
>    7 Seek_Error_Rate         0x000f   084   060   030    Pre-fail
> Always       -       259660219
>    9 Power_On_Hours          0x0032   058   058   000    Old_age
> Always       -       37456
>   10 Spin_Retry_Count        0x0013   100   100   097    Pre-fail
> Always       -       0
>   12 Power_Cycle_Count       0x0032   100   100   020    Old_age
> Always       -       466
> 183 Runtime_Bad_Block       0x0032   100   100   000    Old_age
> Always       -       0
> 184 End-to-End_Error        0x0032   100   100   099    Old_age
> Always       -       0
> 187 Reported_Uncorrect      0x0032   100   100   000    Old_age
> Always       -       0
> 188 Command_Timeout         0x0032   100   098   000    Old_age
> Always       -       66256
> 189 High_Fly_Writes         0x003a   100   100   000    Old_age
> Always       -       0
> 190 Airflow_Temperature_Cel 0x0022   065   052   045    Old_age
> Always       -       35 (Min/Max 31/44)
> 194 Temperature_Celsius     0x0022   035   048   000    Old_age
> Always       -       35 (0 9 0 0)
> 195 Hardware_ECC_Recovered  0x001a   048   033   000    Old_age
> Always       -       148741208
> 197 Current_Pending_Sector  0x0012   100   100   000    Old_age
> Always       -       0
> 198 Offline_Uncorrectable   0x0010   100   100   000    Old_age
> Offline      -       0
> 199 UDMA_CRC_Error_Count    0x003e   200   200   000    Old_age
> Always       -       0
> 240 Head_Flying_Hours       0x0000   100   253   000    Old_age
> Offline      -       272674588759705
> 241 Total_LBAs_Written      0x0000   100   253   000    Old_age
> Offline      -       1149999113
> 242 Total_LBAs_Read         0x0000   100   253   000    Old_age
> Offline      -       1092811368
>
> SMART Error Log Version: 1
> No Errors Logged
>
> SMART Self-test log structure revision number 1
> Num  Test_Description    Status                  Remaining
> LifeTime(hours)  LBA_of_first_error
> # 1  Vendor (0x50)       Completed without error       00% 0 -
>
> SMART Selective self-test log data structure revision number 1
>   SPAN  MIN_LBA  MAX_LBA  CURRENT_TEST_STATUS
>      1        0        0  Not_testing
>      2        0        0  Not_testing
>      3        0        0  Not_testing
>      4        0        0  Not_testing
>      5        0        0  Not_testing
> Selective self-test flags (0x0):
>    After scanning selected spans, do NOT read-scan remainder of disk.
> If Selective self-test is pending on power-up, resume after 0 minute delay.
>
>
> --
> Regards,
>
> Dick Steffens
>
> _______________________________________________
> PLUG mailing list
> PLUG at lists.pdxlinux.org
> http://lists.pdxlinux.org/mailman/listinfo/plug
>



More information about the PLUG mailing list