[PLUG] serial communication over ethernet
Russell Senior
russell at personaltelco.net
Sat Mar 18 00:04:23 UTC 2017
>>>>> "VY" == VY <vyau5678 at gmail.com> writes:
VY> Hello All: I am looking for a mechanism from Linux to configure a
VY> device that's a small ethernet server:
VY> https://www.lantronix.com/wp-content/uploads/pdf/XPort-AR_CR.pdf
VY> The initial steps involve configuring its BAUD rate, IP address
VY> etc.. On Windows, per their instructions, folks are asked to use
VY> things like telnet and hyperterminal, or other serial communication
VY> tools.
VY> On Linux, I have configured serial ports before, using things like
VY> minicom. But those devices would show up as /dev/TTY***. In this
VY> device, it is showing up in an ethernet port.
VY> what tools can I use to configure this device in such scenario under
VY> Linux? I know exactly which ethernet port it is connected to (e.g.
VY> eth1)
VY> thanks in advanced for any tip.
I looked at the PDF and I still can't tell what it is. From what I
could tell, you can connect over serial *or* telnet *or* ssh. So, if
you are connected over ethernet, then you should use ssh or telnet (in
that order).
--
Russell Senior, President
russell at personaltelco.net
More information about the PLUG
mailing list