[PLUG] How do I talk to it

[Chuck Hast]

Folks, I have a radio that uses a USB link to an STMicro device. It shows
up on my laptop as an SDMicroSD Flash. I need a program that I run in
Wine to see it but cannot figure out how to make it visible to the program.

Here is the trace from a console capture:
 Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.086367] usb 1-1.1: new
full-speed USB device number 8 using ehci-pci
Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181567] usb 1-1.1: New USB
device found, idVendor=0483, idProduct=5720
Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181577] usb 1-1.1: New USB
device strings: Mfr=1, Product=2, SerialNumber=3
Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181583] usb 1-1.1: Product: Mass
Storage in FS Mode
Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181588] usb 1-1.1: Manufacturer:
STMicroelectronics
Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181592] usb 1-1.1: SerialNumber:
00000000001B
Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.184059] usb-storage 1-1.1:1.0:
USB Mass Storage device detected
Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.184232] scsi host9: usb-storage
1-1.1:1.0
Jun  9 23:18:49 kp4djt-t420 mtp-probe: checking bus 1, device 8:
"/sys/devices/pci0000:00/0000:00:1a.0/usb1/1-1/1-1.1"
Jun  9 23:18:49 kp4djt-t420 mtp-probe: bus: 1, device: 8 was not an MTP
device
Jun  9 23:18:50 kp4djt-t420 kernel: [ 1136.184189] scsi 9:0:0:0:
Direct-Access     STM      microSD Flash    1.00 PQ: 0 ANSI: 2
Jun  9 23:18:50 kp4djt-t420 kernel: [ 1136.185219] sd 9:0:0:0: Attached
scsi generic sg2 type 0
Jun  9 23:18:50 kp4djt-t420 kernel: [ 1136.191102] sd 9:0:0:0: [sdb]
Attached SCSI removable disk

Any idea of how to make it visible in wine so I can load a code plug into
the
radio?


-- 

Chuck Hast  -- KP4DJT --
I can do all things through Christ which strengtheneth me.
Ph 4:13 KJV
Todo lo puedo en Cristo que me fortalece.
Fil 4:13 RVR1960