[PLUG] How do I talk to it

Chuck Hast wchast at gmail.com
Sun Jun 10 18:18:23 UTC 2018


Ken,
The first thing I did was look in /dev to see if it was there but no joy. I
see the
device appear on my desktop as a ST MicroSD Flash, but I cannot find where
to setup a link to the thing.

On Sun, Jun 10, 2018 at 11:02 AM, Ken Stephens <kennethgstephens at gmail.com>
wrote:

> Chuck,
>
> You need to add a link to it in ~/.wine/dosdevices
>
> Ken
>
> On Sat, Jun 9, 2018 at 9:20 PM Chuck Hast <wchast at gmail.com> wrote:
>
> > Folks, I have a radio that uses a USB link to an STMicro device. It shows
> > up on my laptop as an SDMicroSD Flash. I need a program that I run in
> > Wine to see it but cannot figure out how to make it visible to the
> program.
> >
> > Here is the trace from a console capture:
> >  Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.086367] usb 1-1.1: new
> > full-speed USB device number 8 using ehci-pci
> > Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181567] usb 1-1.1: New USB
> > device found, idVendor=0483, idProduct=5720
> > Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181577] usb 1-1.1: New USB
> > device strings: Mfr=1, Product=2, SerialNumber=3
> > Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181583] usb 1-1.1: Product:
> Mass
> > Storage in FS Mode
> > Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181588] usb 1-1.1:
> Manufacturer:
> > STMicroelectronics
> > Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.181592] usb 1-1.1:
> SerialNumber:
> > 00000000001B
> > Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.184059] usb-storage 1-1.1:1.0:
> > USB Mass Storage device detected
> > Jun  9 23:18:49 kp4djt-t420 kernel: [ 1135.184232] scsi host9:
> usb-storage
> > 1-1.1:1.0
> > Jun  9 23:18:49 kp4djt-t420 mtp-probe: checking bus 1, device 8:
> > "/sys/devices/pci0000:00/0000:00:1a.0/usb1/1-1/1-1.1"
> > Jun  9 23:18:49 kp4djt-t420 mtp-probe: bus: 1, device: 8 was not an MTP
> > device
> > Jun  9 23:18:50 kp4djt-t420 kernel: [ 1136.184189] scsi 9:0:0:0:
> > Direct-Access     STM      microSD Flash    1.00 PQ: 0 ANSI: 2
> > Jun  9 23:18:50 kp4djt-t420 kernel: [ 1136.185219] sd 9:0:0:0: Attached
> > scsi generic sg2 type 0
> > Jun  9 23:18:50 kp4djt-t420 kernel: [ 1136.191102] sd 9:0:0:0: [sdb]
> > Attached SCSI removable disk
> >
> > Any idea of how to make it visible in wine so I can load a code plug into
> > the
> > radio?
> >
> >
> > --
> >
> > Chuck Hast  -- KP4DJT --
> > I can do all things through Christ which strengtheneth me.
> > Ph 4:13 KJV
> > Todo lo puedo en Cristo que me fortalece.
> > Fil 4:13 RVR1960
> > _______________________________________________
> > PLUG mailing list
> > PLUG at pdxlinux.org
> > http://lists.pdxlinux.org/mailman/listinfo/plug
> >
> _______________________________________________
> PLUG mailing list
> PLUG at pdxlinux.org
> http://lists.pdxlinux.org/mailman/listinfo/plug
>



-- 

Chuck Hast  -- KP4DJT --
I can do all things through Christ which strengtheneth me.
Ph 4:13 KJV
Todo lo puedo en Cristo que me fortalece.
Fil 4:13 RVR1960



More information about the PLUG mailing list