[PLUG] Router configuration: connecting laptop [FIXED]
Rich Shepard
rshepard at appl-ecosys.com
Sun Dec 8 01:00:43 UTC 2019
On Sat, 7 Dec 2019, Russell Senior wrote:
> The routes are fine, you don't need to set a route at all. Show us the
> result of "ip a".
It took two reboots of the Dell and then it communicated with the router on
192.168.1.1; the restored configuration apparently didn't take but
communication was on eth1. While I run a single subnet the original
configuration used the WAN2+2LAN2 configuration wizard with eth0 as the WAN
port and eth1-4 bridged as LAN ports.
Rich
More information about the PLUG
mailing list