[PLUG] Hardware troubleshooting: Yamaha headset

Jason Barnett jason.barnett71 at gmail.com
Wed Jun 3 15:44:54 UTC 2020


If your cellphone has a headphone jack, you could try plugging it into that
and make a call. If it works properly then the headset and cord are fine
and you need to troubleshoot your computer.  If it doesn't work properly,
then the cord or headphones are faulty.

On Wed, Jun 3, 2020 at 8:12 AM Rich Shepard <rshepard at appl-ecosys.com>
wrote:

> Playing a music mp3 via audacity and listening with the Yamaha CM500
> headset, the sound came through only the left speaker and was distorted
> (the
> latter might be how audacity's defaults are set).
>
> Yesterday on the ringcentral call I could hear (left ear only and sound was
> not really clear) and the other participants could hear me, but I don't
> know
> if it was the headset mic (which pavucontrol showed was active) or the
> webcam's mic (which pavucontrol now shows as the input device because the
> headset is disconnected.)
>
> I need to determine if this is a warranty issue with the headset or an
> issue
> with the audio out ports on the desktop.
>
> After moving the headset headphone and microphone plugs to the ports at the
> rear of the case pulseaudio-ctl showed one source and neither sink nor
> source muted. pavucontrol showed both the headset and mic turned off (but
> it
> saw the webcam mic and the external speakers.)
>
> The motherboard is an ASUS Prime X470-Pro.
>
> Are there other tests I can run? Are there two issues here: the headset
> headphones not properly working and sound ports on the desktop needing
> adjusting?
>
> I'm open to all suggestions, recommendations, and other advice.
>
> Regards,
>
> Rich
>
> _______________________________________________
> PLUG mailing list
> PLUG at pdxlinux.org
> http://lists.pdxlinux.org/mailman/listinfo/plug
>



More information about the PLUG mailing list